Linux add ethtool duplex settings to a network card permanently Print

  • 57

Changing your Network Interface Speed, Duplex or Auto Negotiate settings on Red Hat Linux

To set the interface speed, duplex or auto negotiation on Linux system boot up (make settings permanent), you need edit /etc/sysconfig/network-scripts/ifcfg-eth0 file for eth0 interface. This file used by Red Hat enterprise Linux, Fedora core, Cent Os etc.

Open the file:
# vi /etc/sysconfig/network-scripts/ifcfg-eth0

Append following line:
ETHTOOL_OPTS="speed 100 duplex full autoneg off"

Save and close the system. It will set the eth0 device to 100Mbs, full duplex, with the auto negotiation off at boot time. You can simply restart the networking (it will disconnect all ssh or ftp session) or restart the server. Depend upon traffic and load it may take upto 1 minute to setup a new port speed:
# /etc/init.d/network restart

If you want 1000Mbs set line as follows:
ETHTOOL_OPTS="speed 1000 duplex full autoneg off"Update: if above command failed to work for 1000Mbps use following command (see below in comment sections for discussion) :ETHTOOL_OPTS="speed 1000 duplex full autoneg on"

Debian or Ubuntu Linux permanent settings

Under Debian or Ubuntu Linux just create a script as follows:
# vi /etc/init.d/100Mbs
OR
$ sudo vi /etc/init.d/100Mbs
Append following lines:
#!/bin/sh
ETHTOOL="/usr/sbin/ethtool"
DEV="eth0"
SPEED="100 duplex full"
case "$1" in
start)
echo -n "Setting eth0 speed 100 duplex full...";
$ETHTOOL -s $DEV speed $SPEED;
echo " done.";;
stop)
;;
esac
exit 0
Save and close the file. Setup executable permission:
# chmod +x /etc/init.d/100MbsOR$ sudo chmod +x /etc/init.d/100Mbs

Now run script when Debian or Ubuntu Linux boots up. Use update-rc.d command install System-V style init script links:# update-rc.d 100Mbs defaultsOR# sudo update-rc.d 100Mbs defaultsOutput:

 Adding system startup for /etc/init.d/100Mbs ...
   /etc/rc0.d/K20100Mbs -> ../init.d/100Mbs
   /etc/rc1.d/K20100Mbs -> ../init.d/100Mbs
   /etc/rc6.d/K20100Mbs -> ../init.d/100Mbs
   /etc/rc2.d/S20100Mbs -> ../init.d/100Mbs
   /etc/rc3.d/S20100Mbs -> ../init.d/100Mbs
   /etc/rc4.d/S20100Mbs -> ../init.d/100Mbs
   /etc/rc5.d/S20100Mbs -> ../init.d/100Mbs

Reboot the system to take effect or just type scrit name:
# /etc/init.d/100Mbs startOR$ sudo /etc/init.d/100Mbs start


Hjalp dette svar dig?

« Tilbage

Powered by WHMCompleteSolution